A. Litre/mole.second
B. Moles/litre.second
C. Litre/mole
D. Litre/second
Correct Answer: Litre/mole.second ✔
Last Updated: February 24, 2019
Related MCQs
- Which of the following is an autocatalytic reaction ?
- An isothermal irreversible reaction is being carried out in an ideal tubular flow reactor. The conversion in this case will __________ with decrease in space time?
- During manufacture of H2SO4, the oxidation of SO2 to SO3 by oxygen is an endothermic reaction. The yield of SO3 will be maximised, if the __________?
- From Arrhenius law, a plot of loge K versus 1/T gives a straight line with a slope of (-E/R). The unit of E/R is__________?
- Pick the WRONG design guideline for a reactor in which the reactions, A → R (desired) and A → S (undesired) are to take place. The ratio of the reaction rates is rR/rS = (k1/k2). CA a-b ?
- Design of heterogamous catalytic reactor involves consideration of __________ steps?
- Holding time for flow reactors is __________ the space time, for constant fluid density ?
- The reactions of high molecularity are rare, because__________?
- The role of a catalyst in a chemical reaction is to change the__________?
- Slurry reactors are characterised by the__________?
- consecutive reaction, as shown in the bellow figure, is characterised by __________?
- A multiple reaction may be classified as a __________ reaction?
- Molecularity of a reaction__________?
- A balanced chemical reaction equation conforms to the law of__________?
- Enzymes (a protein) are catalysts found in organisms. Its efficiency of catalysing a reaction is due to its capacity to lower the activation energy of the reaction. The enzyme ptyalin used for food digestion is present in __________?
- Which of the following chemical reactions will be favoured by low pressure ?
- An isothermal aqueous phase reversible reaction, P ⇌ R, is to be carried out in a mixed flow reactor. The reaction rate in k.mole/m3 .h is given by, r = 0.5CP – 0.125CR. A stream containing only P enters the reactor. The residence time required (in hours) for 40% conversion of P is__________?
- Pick out the wrong statement ?
- The performance of a cascade of CSTR’s can be improved by adding__________?
- According to Arrhenius equation of temperature dependency of rate constant for an elementary reaction __________?
- When the reaction is dominated by intraparticle diffusion, the apparent order of reaction (nD) as measured is related to the true order (n) as __________?
- The equilibrium constant for the reversible reaction as shown in the bellow figure, is affected by the__________?
- . In the converter of the contact process for the manufacture of H2SO4 the equilibrium conversion of SO2 (i) with increase in temperature and (ii) __________ with increase in the mole ratio of SO2 to air?
- Consider the ‘n’ th order irreversible liquid phase reaction A → B. Which one of the following plots involving half life of the reaction (t1/2) and the initial reactant concentration (CA0) gives a straight line plot ?
- In a reaction, the threshold energy is equal to (where, A = activation energy N = normal energy of reactants) ?
- A trickle bed reactor is the one, which__________?
- The rate of reaction of a/an __________ reaction is not affected by temperature rise ?
- The energy balance equation over a tubular reactor under transient conditions is__________?
- Exothermic reactions are best carried out in __________?
- The experimentally determined overall order of the reaction, A + B → C + D, is two. Then the__________?
- Backmixing is most predominant in__________?
- For the chemical reaction X → Y, it is observed that, on doubling the concentration of ‘X’, the reaction rate quadruples. If the reaction rate is proportional to Cx n, then what is the value of „n‟ ?
- An endothermic second order reaction is carried out in an adiabatic plug flow reactor. The rate of heat generation is __________?
- The decomposition of A into B is represented by the exothermic reaction, A ⇌ 2B. To achieve maximum decomposition, it is desirable to carry out the reaction ?
- The excess energy of the reactants required to dissociate into products is known as the __________ energy?
- The knowledge of initial concentration and rate constant is necessary to determine the half life time of a reaction of __________ order?
- An endothermic aqueous phase first order irreversible reaction is carried out in an adiabatic plug flow reactor. The rate of reaction ?
- Which of the following factors control the deactivation of a porous catalyst pellet?
- Carbon particles accumulated on the catalyst used in the gas oil cracking lies in the category of __________ poison?
- For an ideal plug flow reactor, the value of Peclet number is__________?
- In a reversible reaction, a catalyst increases the rate of forward reaction__________?
- In an ideal mixed reactor (at steady state), the __________?
- The importance of diffusion in a catalyst are increased by __________?
- A gaseous reactant is introduced in a mixed reactor of 3 litres volume at the rate of 1 litre/second. The space time is __________ seconds?
- With increase in initial concentration, the fractional conversion of a first order reaction in a given time__________?
- The molecularity and the order of reaction respectively, for the hydrolysis of methyl acetate in presence of acids are__________?
- Which one is the rate controlling step in a solid-gas non-catalytic reaction occurring at very high temperature ?
- The temperature dependence of reaction rate constant (K) by Arrhenius law is given by__________?
- In solid catalysed reactions the diffusional effects are more likely to affect the overall rate of reaction for__________?
- Half-life period for a first order reaction is __________ the initial concentration of the reactant?
- Recycling back of outlet stream to the reactor from an ideal CSTR carrying out a first order liquid phase reaction will result in __________ in conversion?