A. Coal can be pulverised with great difficulty
B. Coal can’t be pulverised
C. Coal can be easily pulverised
D. Power consumption in grinding the coal will be very high
Correct Answer: Coal can be easily pulverised ✔
Last Updated: March 08, 2019
Related MCQs
- In high temperature carbonisation (as compared to low temperature carbonisation) of coal, the__________?
- Which of the following is not a manufactured fuel ?
- Prime coking coal is always blended with medium or non- coking coal before carbonisation__________?
- Low temperature carbonisation of coal takes place at __________ °C?
- With increase in calorific value of fuels, their adiabatic flame temperatures__________?
- Which of the following is not applicable to fluidised bed combustion of coal ?
- Efficiency of the combustion of a fuel is judged by the __________ the flue gas?
- Preheating of a gaseous fuel results in increased__________?
- Mineral matter content (M) and ash content A. in coal are approximately related as __________?
- Which of the following gaseous fuels is likely to have the highest gross calorific value ?
- Coke oven gas compared to blast furnace gas is__________?
- Which of the following reactions occuring during coal gasification is called the Neumann reversal reaction ?
- Calorific value of gobar gas (containing CH4 = 60% , H2 = 10% ; CO2 = 30%) may be about __________ Kcal/Nm3?
- Calorific value as determined by bomb calorimeter is the__________?
- Which adsorbent is used for removing sulphur compounds (S Q, H2S, RSH etc.) removal from coke oven gas in by-products recovery plant ?
- Which of the following fuels has the highest calorific value per unit mass (kcal/kg) ?
- Fusion point of coal ash generally varies from 1000 to 1700° C. Ash having fusion point less than __________ °C is liable to form clinker?
- The calorific value of natural gas is about __________ kcal/Nm3?
- High amount of sulphur and phosphorous in coke causes __________ ?
- A coal containing high amount of volatile matter will have__________?
- Coke oven gas is a better fuel than blast furnace gas, because of its higher__________?
- Which of the following is not a micro component present in coal ?
- Which of the following would require maximum amount of % excess air for complete combustion ?
- Coking time in a commercial high temperature coal carbonisation plant is about __________ hours?
- With increase in C/H ratio of a fuel, the dew point of flue gases__________?
- High temperature carbonisation of coal takes place at __________ °C?
- When the coal is heated in absence of air, it is called its __________?
- Out of the following fuels, the difference between gross and net calorific value will be minimum in case of__________?
- A good quality coal should have __________?
- Shatter index of metallurgical coke on 2 inches and 0.5 inch screen should be respectively around __________ percent?
- Which of the following is a measure of the agglutinating (i.e., binding) property of coal ?
- By-products recovery process from coal carbonisation is termed as direct, indirect and semi direct process depending upon the method of recovery of__________?
- Low temperature oxidation of coal is accelerated by the__________?
- As the C/H ratio of the fuel increases, the amount of CO2 formed on combustion __________ for the same percentage of excess air?
- Preheating of __________ the flame temperature?
- With increase in the time of carbonisation at a particular temperature (say 1000°C), the __________ percentage in coke oven gas increases?
- If CO2 is not fully absorbed by the KOH solution meant for its absorption in the orsat apparatus, it will appear as__________?
- Presence of force moisture in coal is most disadvantageous during its __________?
- High ash coals __________?
- Moisture loss is determined by the __________?
- Coal is heated in absence of air for 7 minutes at a temperature of about __________ °C, during its volatile matter determination for proximate analysis?
- Lurgi gasifier (high pressure gasifier) as compared to Kopper Totzek gasifier (atmospheric pressure gasifier) produces __________?
- Yield of blast furnace gas is about __________ Nm3 /ton of pig iron?
- Emission of dense white smoke out of the chimney of a thermal power plant is an indication of the use of__________?
- Which of the following is a rich fuel gas ?
- With increases in carbonisation temperature__________?
- 64-132) rank coal (ASTM) means a coal with 64%__________?
- A liquid/gaseous fuel containing hydrocarbons and high amount of sulphur is burnt with 40% excess air. The flue gas still contains large amount of carbon monoxide. This may be due to the__________?
- Which of the following fertilisers is produced in the by-products recovery (from coke oven gas) plant attached to an integrated steel plant ?
- Main constituent of natural gas is __________?
- Froth floatation is used for__________?