A. 0°K
B. 0°C
C. 100°C
D. Room temperature
Correct Answer: 0°K ✔
Last Updated: March 03, 2019
Related MCQs
- The dimensionless group in mass transfer that is equivalent to Prandtl number in heat transfer is__________?
- Loss of heat from untagged steam pipe to the ambient air is by __________?
- In Biot number, the characteristic length used is the ratio of the __________ of the solid?
- Boiling point elevation for a strong and concentrated solution is found by Duhring’s rule, which states that at the same pressure, the boiling point of a solution is a linear function of the __________ of pure water?
- Stefan-Boltzmann law which describes the radiation heat transfer states that, it is proportional to (where, t = temperature in °C T = absolute temperature in ° K) ?
- The equation, (NSt × N2/3 Pr) = f/2, is the __________ analogy ?
- The range of electromagnetic spectrum important in heat transfer by radiation is __________ microns?
- Boiling point of a solution according to Duhring’s rule is a linear function of the __________ of water?
- Prandtl number for most of dry gases is about__________?
- Extremely large or small volumes of fluids are generally best routed through the shell side of a shell and tube heat exchanger, because of the__________?
- The purpose of providing expansion bellows in the shell of tubular exchanger is to __________?
- Multipass heat exchangers are used__________?
- It is not recommended to use a 1-2 shell and tube heat exchanger for a particular heat duty, whenever the LMTD correction factor is__________?
- Finned tube heat exchangers__________?
- Fruit juice (a heat sensitive material) can be concentrated in a __________ evaporator?
- The Sieder-Tate correlation for heat transfer in turbulent flow in pipe gives Nu α Re0.8, where, Nu is the Nusselt number and Re is the Reynolds number for the flow. Assuming that this relation is valid, the heat transfer co-efficient varies with the pipe diameter D. as __________?
- For heat flow through very thick walled cylinder, use __________mean radius?
- In a shell and tube heat exchanger, the shell side fluid velocity can‟t be changed by changing the__________?
- LMTD for evaporators & condensers for a given terminal parameters & set of conditions for counter-flow is equal to that for parallel flow. In such heat exchangers, with one of the fluids condensing or evaporating, the surface area required is the least in the __________ flow?
- The maximum heat transfer co-efficient from steam heating will be attained when the steam is__________?
- The film co-efficient is decreased due to the presence of non-condensing gases in the vapors. The film co-efficient of superheated vapor as compared to that of saturated vapor is__________?
- Which of the following has maximum thermal conductivity ?
- Thermal diffusivity of a material __________?
- Nusselt number is the ratio of the temperature gradient at the wall to__________?
- What is the unit of thermal conductivity ?
- Tubes are held between top and bottom tube sheets in Calandria type evaporator by keeping__________?
- What is the emissivity of a black body ?
- In SI units, thermal conductivity is expressed in__________?
- In pipe flow, heat is transferred from hot wall to the liquid by__________?
- Heat transfer rate described by Fourier’s law will decrease, if the __________ increases?
- In a co-current double pipe heat exchanger used for condensing saturated steam over the inner tube, if the entrance and exit conditions of the coolant are interchanged, then the rate of condensation will__________?
- Which one gives the monochromatic emissive power for black body radiation ?
- Absorptivity and reflectivity of a perfect black body are respectively __________?
- Water is normally used as a coolant in the heat exchange equipments mainly because of its__________?
- Stefan-Boltzmann law applies to __________ body?
- A BTU/hr.ft.2 °F is equal to__________?
- A __________ evaporator employs an annular downtake?
- With increase in temperature, the thermal conductivity of fresh lubricating oil __________?
- To reduce the tube side pressure drop for the same flow rate, the heat exchanger recommended is __________?
- In case of __________ boiling, the liquid temperature is below the saturation temperature and the boiling takes place in the vicinity of the heated surface?
- For __________ Prandtl number values, the heat conduction will be negligible in the buffer zone?
- Terminal point temperature differences between fluids in case of a heat exchanger is termed as__________?
- A composite wall consists of two plates A and B placed in series normal to the flow of heat. The thermal conductivities are kA and kB and the specific heat capacities are CPA and CPB for plates A and B respectively. Plate B has twice the thickness of plate A. At steady state, the temperature difference across plate A is greater than that across plate B, when__________?
- Overall heat transfer co-efficient of a particular tube is U1. If the same tube with some dirt deposited on either side has coefficient U2, then__________?
- Maximum heat transfer rate is achieved in __________ flow?
- Radiator of an automobile engine is a __________ type of heat exchanger?
- In forced convection, the Nusselt number is a function of __________?
- In a shell and tube type heat exchanger, the floating tube bundle heat arrangement is used__________?
- The Stefan-Boltzmann constant depends on the__________?
- For large heat transfer area requirement, shell and tube heat exchanger is preferred, because it__________?
- A body cools down from 75°C to 70°C in 10 minutes. It will cool down from 70° C to 65° C in __________ minutes?