A. Facilitate the cleaning of outer tube surface
B. Enhance turbulence
C. Hold the tubes in position
D. All A , B & C
Correct Answer: Enhance turbulence ✔
Last Updated: March 03, 2019
Related MCQs
- Steam side heat transfer co-efficient in an evaporator is in the range of __________ kcal/hr.m2°C?
- The ratio of total radiating power to the absorptivity of the body depends upon the __________ as per Kirchoff‟s law?
- For small temperature difference, the heat transfer rate as per Newton’s law of cooling is proportional to (where, Δt = excess temperature) ?
- Overall heat transfer co-efficient for cooling of hydrocarbons by water is about__________?
- Intermittent tube cleaning is possible to be done in case of a __________ evaporator?
- In case of vertical tube evaporator, with increase in liquor level, the overall heat transfer co-efficient__________?
- In evaporators, lowering the feed temperature__________?
- Shell side pressure drop in a shell and tube heat exchanger does not depend upon the__________?
- The most conducive surface for dropwise condensation to occur is the __________ surface?
- Out of 100 kcal/second of incident radiant energy on the surface of a thermally transparent body, 300 kcal/second is reflected back. If the transmissivity of the body is 0.25, the emissivity of the surface will be__________?
- The critical radius of insulation for a spherical shell is (where, K = thermal conductivity of insulating material h0 = heat transfer coefficient at the outer surface) ?
- Analogy between mass and heat transfer is not applicable in case of__________?
- An evaporator while concentrating an aqueous solution from 10 to 40% solids evaporates 30000 kg of water. The amount of solids handled by the system in kg is__________?
- Steady state one dimensional heat flow by conduction as given by Fourier’s low does not assume that__________?
- Heat transfer co-efficient (h1) for liquids increases with__________?
- Multiple effect evaporators ar used to__________?
- In natural convection heat transfer, the correlating parameter is the__________?
- Correction is applied to LMTD for __________ flow?
- Increasing the liquor level in the evaporator results in the__________?
- In case of a shell and tube heat exchanger, the minimum and maximum baffle spacing is respectively (where, D = inside diameter of the shell) ?
- Double pipe heat exchangers are used__________?
- A body is called grey if the monochromatic emissivity of the body is__________?
- While the total emissivity of a perfect black body is unity, the same for a real body is__________?
- Crystal size in a continuous crystalliser depends upon the__________?
- Boiling of milk in an open vessel is an example of __________ boiling?
- Black liquor generated during paper manufacture is concentrated in a__________?
- What is Nusselt number ?
- In the equation Q = UAΔt; Δt is__________?
- For a cold dilute feed to produce thick viscous liquor, backward feeding as compared to forward feeding results in__________?
- Hot water (0.01 m3 /min) enters the tube side of a counter current shell and tube heat exchanger at 80°C and leaves at 50°C. Cold oil (0.05 m3/min) of density 800 kg/m3 and specific heat of 2 kJ/kg.K enters at 20°C. The log mean temperature difference in °C is approximately ?
- Graetz number is given by__________?
- Reynold’s analogy states that__________?
- Which of the following has the minimum thermal conductivity ?
- For an ideal black body__________?
- For concentrating an aqueous solution of a material like anhydrous Na2SO4, whose solubility decreases with rise in temperature, the most suitable evaporator is a __________ evaporator?
- Leidenfrost point is a term concerned with the__________?
- Which of the following is not used as a medium for high temperature heating ?
- The inside heat transfer co-efficient in case of turbulent flow of liquid in the tube side in a 1-2 shell and tube heat exchanger is increased by __________ times, when the number of tube passes is increased to 8?
- In regenerative air preheater (as practised in heating of coke ovens), the heat is transferred__________?
- A multiple effect evaporator has a capacity to process 4000 kg of solid caustic soda per day, when it is concentrating from 10% to 25% solids. The water evaporated in kg per day is__________?
- The Nusselt number for fully developed (both thermally and hydrodynamically) laminar flow through a circular pipe whose surface temperature remains constant is__________?
- Which characteristic of a fluid is not important in deciding its route in a shell and tube heat exchanger ?
- What is the absorptivity of a black body?
- Economy of a multiple effect evaporator is not influenced much by the__________?
- Asymptotic conditions is reached, when for a fluid flowing in laminar flow through a long tube__________?
- In case of evaporators, liquid entrainment results primarily due to__________?
- Heat exchangers operating, when the asymptotic range is reached, ?
- In counter flow compared to parallel flow, ?
- Mode of heat transfer involved in the cooling of air cooled internal combustion engine is__________?
- In a single effect evaporator, the economy is__________?
- Small scale evaporation is done in a__________?