Home
About Us
Contact Us
Privacy Policy
Search
Home
→
Petroleum Refinery Engineering
→
Octane numbers of motor gasoline used in India and America are respectively________________?
Related MCQs
Which one is preferred for aircraft engine ?
hich of the following is the most suitable feed for platforming process (reforming) ?
The condensate obtained on compression of wet natural gas is termed as__________?
In catalytic alkylation, higher iso-butane to olefin ratio gives__________?
Solvent used in Edeleanu process is__________?
Reid vapour pressure of gasoline is the measure of its__________?
Pick out the correct statement about catalytic polymerisation ?
Which one of the following processes aims at producing higher yield of gaseous unsaturated hydrocarbons and aromatics like benzene & toluene ?
Cetane number of diesel used in trucks may be about __________?
With increase in density, the viscosity of petroleum products __________?
Visbreaking process is used mainly for making__________?
Mercaptans are added to liquefied petroleum gas (LPG) to __________ ?
Research octane number refers to the__________?
Which of the following is used as a catalyst in fluidised bed catalytic cracking ?
Aniline point is the __________?
Raw Kerosene has a smoke point of 15 mm. After it is subjected to dearomatization by liquid SO2 extraction (Edeleanu process), its smoke point may become __________ mm?
Smoke point of a test sample of kerosene is found to be 15 mm. On removal of __________ from it, the smoke point rises to 25 mm?
The most commonly used feed stock for the reforming reactor is __________?
Crude oils containing more than __________ kg of total salts (expressed in terms of NaCl) per thousand barrel is called a ‘salty crude’ ?
Octane number of gasoline is a measure of its__________?
In Hydrofining catalytic desulphurisation process for sweetening of petroleum products, use of hydrogen__________?
Alkylation__________?
Illuminating characteristics of kerosene is expressed by its__________?
Pressure maintained in the high pressure primary tower of a three stage crude oil distillation system is about __________ kg/cm2?
Crude oil produced by Indian oil fields are predominantly __________ in nature?
Complete removal of __________ from gasoline is done by Unisol process using caustic soda and methyl alcohol?
Which of the following has the lowest flash point of all ?
High aniline point of diesel indicates that, it __________?
Flash point of motor gasoline may be around __________ °C?
Which of the following has the highest viscosity of all (at a given temperature) ?
Viscosity index of a lubricating oil__________?
Fuel oil is subjected to visbreaking to reduce its__________?
Both asphalt and wax are produced by __________ base crude oils?
__________ converts n-paraffins to i-paraffins ?
A petroleum well is called ‘dry’, if it contains __________?
In solutizer sweetening process, solutizer solution used is__________?
Solvent used in the deasphalting process is __________?
Cetane number of high speed diesel must be ≥__________?
Boiling range of motor gasoline is an indication of the __________?
Furfural solvent extraction is used for upgrading (by dissolving aromatics) ?
Which of the following has the highest octane number ?
Which of the following processes consumes hydrogen ?
Catalyst used in catalytic reforming is__________?
Penetration test determines the __________ of the grease?
In case of liquid petrofuels, momentary combustion is observed at its __________?
__________ is not an important refinery process for upgrading the quality of lubricating oil ?
Petroleum __________ ?
Which of the following contains maximum sulphur ?
The colour of gasoline is an indication of its __________?
In petroleum refining, the process used for conversion of hydrocarbons to aromatics is__________?
Isomerisation converts the __________ tot-paraffins?
Octane numbers of motor gasoline used in India and America are respectively________________?
A. 87 & 94
B. 94 & 87
C. 94 & 100
D. 83 & 100
Correct Answer:
87 & 94
✔
Last Updated:
March 02, 2019