Home
About Us
Contact Us
Privacy Policy
Search
Home
→
Petroleum Refinery Engineering
→
Preheating temperature of medium viscosity furnace oil for better atomisation through burner is about _______________ °C ?
Related MCQs
Which of the following is a Naphthene ?
Which is almost absent in crude petroleum ?
Hydrocracking employs __________?
Straight run naphtha is converted into high octane number petrol (gasoline) by catalytic__________?
‘Solvent naphtha’ used mostly as a solvent in paints and perfumery is produced by the __________ of virgin naphtha into small boiling range cuts?
Refractive index of a petrofuel which is the ratio of velocity of light in air to its velocity in the petrofuel gives an indication if its__________?
Octane number (unleaded) of gasoline produced by isomerisation of butane may be about __________?
Molecular weight of crude petroleum may be around__________?
The characterisation factor of crude petroleum oil is around__________?
True vapour pressure of a petroleum fraction __________ Reid vapour pressure?
A typical yield of diesel in straight run distillation of crude oil may be about __________ percent?
Crude topping column operates at __________ pressure?
Catalyst used in the catalytic polymerisation is__________?
Gasoline extracted from natural gas (by compression and cooling) is called the __________ gasoline?
__________ chloride present in crude petroleum as impurity is the most prolific producer of HCl during distillation?
Clay treatment is used to remove __________ ?
Which of the following is the easiest to crack ?
Which parameter is used for the grading of paraffin waxes ?
Higher vapour pressure of gasoline indicates __________?
1 centistoke is equal to __________ Redwood I seconds?
Which of the following fractions of petroleum contains maximum sulphur ?
Good quality kerosene should have__________?
Catalyst used in alkylation process is__________?
Cracking is__________?
Concentration of H2SO4 catalyst in alkylation is kept between 90-98%, because H2SO4 having concentration?
The conductivity of crude oil-water mixture depends on the__________?
Octane number of n-heptane is assumed to be__________?
Which of the following does not require preheating during storage in the storage tank as well as during atomisation through burners ?
Catalyst used in isomerisation process is __________ ?
Char value of Kerosene is the amount of charred oil deposition on the wick obtained after burning it in a standard wick lamp at a standard rate for 24 hours. Char value of a good quality kerosene should be less than __________ mg/kg of kerosene?
LPG stands for __________?
Salt content (measured as sodium chloride) in electrically desalted crude oil comes down to a level of about __________ ptb (pounds per thousand barrel) ?
Natural gas recovered along with crude oil from oil wells is called wet natural gas which has a higher __________ compared to the dry natural gas?
Which of the following has the minimum °API gravity of all ?
Reforming converts__________?
Higher boiling fractions like atmospheric residue is distilled under vacuum at low temperature because at high temperature, there is a tendency of the predominance of __________?
The best method of determining sulphur in crude oil is by the __________ method?
Which of the following reactions is undesirable in the production of catalytically reformed gasoline ?
The most important property for a jet fuel is its__________?
Vacuum maintained in the vacuum distillation tower of the crude distillation plant is about __________ mm Hg (absolute)?
Which of the following is not an important property of fuel oil/furnace oil ?
High aniline point of a petrofuel (say diesel) indicates that __________?
The vacuum maintained in vacuum distillation unit for reduced crude is about __________ mm Hg?
Liquefied Petroleum Gas (LPG) is mainly a mixture of __________?
Which of the following has the lowest cetane number ?
Pressure & temperature maintained in catalytic cracking is about__________?
In catalytic cracking, the__________?
Carbon percentage (by weight) in crude petroleum may be about__________?
CnH2n is the general formula for__________?
Which of the following has maximum hydrogen/carbon ratio (by weight) ?
Preheating temperature of medium viscosity furnace oil for better atomisation through burner is about _______________ °C ?
A. 50
B. 70
C. 90
D. 140
Correct Answer:
90
✔
Last Updated:
March 01, 2019