A. providing buttresses at certain intervals
B. providing a deeper foundation
C. using a richer mortar
D. using stronger bricks
Correct Answer: providing buttresses at certain intervals ✔
Last Updated: January 20, 2019
Related MCQs
- The basic stress in masonry units having height to width ratio of 1.5 may be increased by a factor of__________?
- A 200 mm thick wall made of modular bricks is 5 m long between cross walls and 3.8 m clear height between RCC slabs at top and bottom. The slenderness ratio of the wall is__________?
- The mortars used for masonry construction are classified based on strength in IS 2250 and IS 1905 according to their designations L1,L2, H1, H2, M, M2.
- In the case of panel wall subjected to horizontal loads at right angles to the plane of the wall, with the mortar not leaner than Ml type, tensile stress in bending in the vertical direction may be allowed to the extent of __________?
- Assertion A : Limiting value of slenderness ratio for a column is less than that of a wall. Reason R : A column can buckle around either of the two horizontal axes while a wall can buckle around only one axis.
- Direct load carrying capacity of a brick masonry wall standing freely as against when it supports RC slab will be__________?
- A high lime content in a composite cement-lime mortar results in__________?
- The use of relatively weak mortar__________?
- In a cavity wall, both leaves of which are load bearing, the effective thickness is taken as__________?
- For earthquake resistant masonry buildings, the vertical distance between openings one above the other in a load bearing wall shall not be less than__________?
- Minimum compressive strength in N/mm2 for H1 type mortar used for masonry is__________?
- Which of the following will give higher ratio of brickwork strength to mortar strength ?
- The timber floor not spanning on the masonry wall but properly anchored to the wall gives__________?
- The mode of failure of a very short masonry member having h/t ratio of less than 4 is by __________?
- If the eccentricity ratio is more than 1/24, then increase in the permissible stress in the design of wall subjected to eccentric loading as per code is__________?
- A free standing brick wall 20 cm thick is subjected to a wind pressure of 75kg/m2. The maximum height of wall from stability consideration is__________?
- The thickness of each leaf of a cavity wall shall not be less than__________?
- The effective height of free standing nonload bearing wall and column respectively will be__________?