A. 0.00018 nrVsec
B. 0.0045 m3/sec
C. 0.18m3/sec
D. 0.1125m3/sec
Correct Answer: 0.00018 nrVsec ✔
Last Updated: January 13, 2019
Related MCQs
- Total number of stress components at a point within a soil mass loaded at its boundary is__________?
- The total discharge from two wells situated near to each other is__________?
- Due to a rise in temperature, the viscosity and the unit weight of the percolating fluid are reduced to 60% and 90% respectively. If other things remain constant, the coefficient of permeability__________?
- Which of the following methods is more suitable for the determination of permeability of clayey soil ?
- Coefficient of permeability of soil__________?
- Effective stress is__________?
- Which of the following methods is best suited for determination of permeability of coarse-grained soils ?
- If the permeability of a soil is 0.8 mm/sec, the type of soil is__________?
- The hydraulic head that would produce a quick condition in a sand stratum of thickness 1.5 m, specific gravity 2.67 and voids ratio 0.67 is equal to__________?
- Effective stress on soil__________?
- Physical properties of a permeant which influence permeability are__________?
- According to IS classification, the range of silt size particles is__________?
- If the water table rises upto ground surface, then the__________?
- Highway Research Board (HRB) classification of soils is based on__________?
- Rise of water table above the ground surface causes__________?
- Quick sand is a__________?
- The total and effective stresses at a depth of 5 m below the top level of water in a swimming pool are respectively__________?
- The clay mineral with the largest swelling and shrinkage characteristics is__________?
- Sand particles are made of__________?
- Dispersed type of soil structure is an arrangement comprising particles having__________?
- Inorganic soils with low compressibility are represented by__________?
- If the material of the base of the Casagrande liquid limit device on which the cup containing soil paste drops is softer than the standard hard rubber, then__________?
- Which of the following soils has more plasticity index ?
- If the natural water content of soil mass lies between its liquid limit and plastic limit, the soil mass is said to be in__________?
- Toughness index is defined as the ratio of__________?
- At liquid limit, all soils possess__________?
- The water content of soil, which represents the boundary between plastic state and liquid state, is known as__________?
- The admixture of coarser particles like sand or silt to clay causes__________?
- When the plastic limit of a soil is greater than the liquid limit, then the plasticity index is reported as__________?
- If the plasticity index of a soil mass is zero, the soil is__________?
- According to Atterberg, the soil is said to be of medium plasticity if the plasticity index PI is__________?
- The hydrometer method of sedimentation analysis differs from the pipette analysis mainly in__________?
- Uniformity coefficient of a soil is__________?
- Which of the following is a measure of particle size range ?
- Stoke’s law is valid only if the size of particle is__________?
- A soil has a bulk density of 22 kN/m3 and water content 10 %. The dry density of soil is__________?
- For proper field control, which of the following methods is best suited for quick determination of water content of a soil mass ?
- In hydrometer analysis for a soil mass__________?
- A pycnometer is used to determine__________?
- If the sand in-situ is in its densest state, then the relative density of sand is__________?
- If the degree of saturation of a partially saturated soil is 60%, then air content of the soil is__________?
- The ratio of volume of voids to the total volume of soil mass is called__________?
- Which of the following methods is most accurate for the determination of the water content of soil ?
- Relative density of a compacted dense sand is approximately equal to__________?
- If the water content of a fully saturated soil mass is 100%, then the voids ratio of the sample is__________?
- If the volume of voids is equal to the volume of solids in a soil mass, then the values of porosity and voids ratio respectively are__________?
- Select the correct range of density index,ID __________?
- When the degree of saturation is zero, the soil mass under consideration represents__________?
- Valid range for S, the degree of saturation of soil in percentage is__________?
- Valid range for n, the percentage voids, is__________?
- Residual soils are formed by__________?