Home
About Us
Contact Us
Privacy Policy
Search
Home
→
Analog Electronics
→
An n- channel JFET has IDSS=2mA,and Vp=-4v.Its transconductance gm=in mA/V)for an applied gate to source voltage VGS=-2v is___________?
Related MCQs
The effective channel length of a MOSFET in a saturation decreases with increase in__________?
A differential amplifier is invariably used in the i/p stage of all OP-amps. This is done basically to provide the OP-amps with a very high_________?
An OPAMP has a slew rate of 5 V/μ S .The largest sine wave O/P voltage possible at a frequency of 1 MHZ is [Hint: Slew rate is defined as the max. rate of change of output voltage. Its unit is V/μS.
A source follower using an FET usually has a voltage gain which is__________?
The early effect in a bipolar junction transistor is caused by__________?
In an op-amp differentiator:__________?
In deriving ac equivalent circuit for an amplifier circuit, we short circuit__________?
When a transistor is connected in common emitter mode, it with have__________?
In a transistor leakage current mainly depends on__________?
Voltage Series feedback also called series-shunt feedback) results in__________?
To prevent a DC return between source and load, it is necessary to use__________?
The current gain of a BJT is__________?
An ideal OP-AMP is an ideal__________?
An amplifier without feedback has a voltage gain of 50,input resistance os 1 KΩ & Output resistance of 2.5KΩ.The input resistance of the current-shunt negative feedback amplifier using the above amplifier with a feedback factor of 0.2 is__________?
In the differential voltage gain & the common mode voltage gain of a differential amplifier are 48db &2db respectively, then its common mode rejection ratio is__________?
A 741-type OP-AMP has a gain-bandwidth product of 1MHz. A non-inverting amplifier using this op-amp & having a voltage gain of 20db will exhibit -3db bandwidth of__________?
A dc power supply has no-load voltage of 30v,and a full-load voltage of 25v at full-load current of 1A.Its output resistance & load regulation ,respectively are__________?
Most of the linear ICs are based on the two-transistor differential amplifier because of its__________?
The bandwidth of an RF tuned amplifier is dependent on__________?
A constant current signal across a parallel RLC circuits gives an o/p of 1.4v at the signal frequency of 3.89KHZ and 4.1KHZ .At the frequency of 4KHZ,the o/p voltage will be__________?
In a p-n junction diode under reverse bias , the magnitude of electric field is maximum at__________?
A change in the value of the emitter resistance Re in a differential amplifier?
Thermal runaway is not possible in FET because as the temperature of FET increases__________?
Which of the following is not associated with a p-n junction?
An n- channel JFET has IDSS=2mA,and Vp=-4v.Its transconductance gm=in mA/V)for an applied gate to source voltage VGS=-2v is___________?
A. 0.25
B. 0.5
C. 0.75
D. 1
Correct Answer:
0.5
✔
Last Updated:
December 19, 2018