A. current controlled capacitor
B. voltage controlled capacitor
C. current controlled inductor
D. voltage controlled inductors
Correct Answer: voltage controlled capacitor ✔
Last Updated: December 19, 2018
Related MCQs
- Which of the following amplifier circuit using junction transistor has the best gain?
- The horizontal intercept of dc load line is the same as ideal__________?
- In a CB amplifier the maximum efficiency could be__________?
- Introducing a resistor in the emitter of a common amplifier stabilizes the dc operating point against variations in__________?
- The most commonly used amplifier in sample & hold circuits is__________?
- In a full-wave rectifier using two ideal diodes,Vdc & Vm are the dc & peak values of the voltage respectively across a resistive load. If PIV is the peak inverse voltage of the diode, then the appropriate relationships for this rectifier is__________?
- The action of JFET in its equivalent circuit can best be represented as a__________?
- Generally, the gain of a transistor amplifier falls at high frequencies due to the__________?
- The current gain of a bipolar transistor drops at high frequencies because of__________?
- Negative feedback in an amplifier__________?
- Class AB operation is often used in power large signal amplifiers in order to_________?
- An n- channel JFET has IDSS=2mA,and Vp=-4v.Its transconductance gm=in mA/V)for an applied gate to source voltage VGS=-2v is__________?
- The effective channel length of a MOSFET in a saturation decreases with increase in__________?
- A differential amplifier is invariably used in the i/p stage of all OP-amps. This is done basically to provide the OP-amps with a very high_________?
- An OPAMP has a slew rate of 5 V/μ S .The largest sine wave O/P voltage possible at a frequency of 1 MHZ is [Hint: Slew rate is defined as the max. rate of change of output voltage. Its unit is V/μS.
- A source follower using an FET usually has a voltage gain which is__________?
- The early effect in a bipolar junction transistor is caused by__________?
- In an op-amp differentiator:__________?
- In deriving ac equivalent circuit for an amplifier circuit, we short circuit__________?
- When a transistor is connected in common emitter mode, it with have__________?
- In a transistor leakage current mainly depends on__________?
- Voltage Series feedback also called series-shunt feedback) results in__________?
- To prevent a DC return between source and load, it is necessary to use__________?
- The current gain of a BJT is__________?
- An ideal OP-AMP is an ideal__________?
- An amplifier without feedback has a voltage gain of 50,input resistance os 1 KΩ & Output resistance of 2.5KΩ.The input resistance of the current-shunt negative feedback amplifier using the above amplifier with a feedback factor of 0.2 is__________?
- In the differential voltage gain & the common mode voltage gain of a differential amplifier are 48db &2db respectively, then its common mode rejection ratio is__________?
- A 741-type OP-AMP has a gain-bandwidth product of 1MHz. A non-inverting amplifier using this op-amp & having a voltage gain of 20db will exhibit -3db bandwidth of__________?
- A dc power supply has no-load voltage of 30v,and a full-load voltage of 25v at full-load current of 1A.Its output resistance & load regulation ,respectively are__________?
- Most of the linear ICs are based on the two-transistor differential amplifier because of its__________?
- The bandwidth of an RF tuned amplifier is dependent on__________?
- A constant current signal across a parallel RLC circuits gives an o/p of 1.4v at the signal frequency of 3.89KHZ and 4.1KHZ .At the frequency of 4KHZ,the o/p voltage will be__________?
- In a p-n junction diode under reverse bias , the magnitude of electric field is maximum at__________?
- A change in the value of the emitter resistance Re in a differential amplifier?
- Thermal runaway is not possible in FET because as the temperature of FET increases__________?
- Which of the following is not associated with a p-n junction?