A. resistor between source and load
B. inductor between source and load
C. capacitor between source and load
D. either A. or B.
Correct Answer: capacitor between source and load ✔
Last Updated: December 19, 2018
Related MCQs
- The current gain of a BJT is__________?
- An ideal OP-AMP is an ideal__________?
- An amplifier without feedback has a voltage gain of 50,input resistance os 1 KΩ & Output resistance of 2.5KΩ.The input resistance of the current-shunt negative feedback amplifier using the above amplifier with a feedback factor of 0.2 is__________?
- In the differential voltage gain & the common mode voltage gain of a differential amplifier are 48db &2db respectively, then its common mode rejection ratio is__________?
- A 741-type OP-AMP has a gain-bandwidth product of 1MHz. A non-inverting amplifier using this op-amp & having a voltage gain of 20db will exhibit -3db bandwidth of__________?
- A dc power supply has no-load voltage of 30v,and a full-load voltage of 25v at full-load current of 1A.Its output resistance & load regulation ,respectively are__________?
- Most of the linear ICs are based on the two-transistor differential amplifier because of its__________?
- The bandwidth of an RF tuned amplifier is dependent on__________?
- A constant current signal across a parallel RLC circuits gives an o/p of 1.4v at the signal frequency of 3.89KHZ and 4.1KHZ .At the frequency of 4KHZ,the o/p voltage will be__________?
- In a p-n junction diode under reverse bias , the magnitude of electric field is maximum at__________?
- A change in the value of the emitter resistance Re in a differential amplifier?
- Thermal runaway is not possible in FET because as the temperature of FET increases__________?
- Which of the following is not associated with a p-n junction?