A. is independent of frequency
B. is inverseh’proportional to frequency
C. increases linearly with frequency
D. decreases linearly with frequency
Correct Answer: increases linearly with frequency ✔
Last Updated: December 23, 2018
Related MCQs
- Addition of zeros in transfer function causes which of the following ?
- If a step function is applied to the input of a system and the output remains below a certain level for all the time, the system is__________?
- Velocity error constant of a system is measured when the input to the system is unit __________ function?
- The type 2 system has __________ at the origin?
- Static error coefficients are used as a measure of the effectiveness of closed loop systems for specified __________ input signal?
- Spring constant in force-voltage analogy is analogous to__________?
- The frequency and time domain are related through which of the following ?
- The type 1 system has _________ at the origin?
- A conditionally stable system exhibits poor stability at__________?
- An increase in gain, in most systems, leads to__________?
- In a system low friction co-efficient facilitates__________?
- In order to increase the damping of a badly underdamped system which of following compensators may be used ?
- Which of the following can be measured by the use of a tachogenerator ?
- Which of the following is the definition of proportional band of a controller ?
- Which of the following devices is used for conversion of co-ordinates ?
- A phase lag lead network introduces in the output__________?
- When the initial conditions of a system are specified to be zero it implies that the system is__________?
- When the initial conditions of a system are specified to be zero it implies that the system is__________?
- A differentiator is usually not a part of a control system because it__________?
- In a control system integral error compensation __________ steady state error?
- An amplidyne can give which of the following characteristics ?
- __________directly converts temperature into voltage?
- Which of the following is exhibited by Root locus diagrams ?
- Which of the following is the output of a thermocouple ?
- __________From which of the following transfer function can be obtained ?
- __________By which of the following the system response can be tested better ?
- __________is the reference input minus the primary feedback?
- With feedback __________ increases?
- In a system zero initial condition means that__________?
- signal will become zero when the feedback signal and reference signs are equal?
- The transfer function is applicable to which of the following ?
- A signal other than the reference input that tends to affect the value of controlled variable is known as__________?
- The transient response of a system is mainly due to__________?
- The temperature, under thermal and electrical system analogy, is considered analogous to__________?
- In electrical-pneumatic system analogy the current is considered analogous to__________?
- In force-voltage analogy, velocity is analogous to__________?
- In liquid level and electrical system analogy, voltage is considered analogous to__________?
- In thermal-electrical analogy charge is considered analogous to__________?
- The viscous friction co-efficient, in force-voltage analogy, is analogous to__________?
- Mass, in force-voltage analogy, is analogous to__________?
- The capacitance, in force-current analogy, is analogous to__________?
- In an automatic control system which of the following elements is not used ?
- Due to which of the following reasons excessive bond width in control systems should be avoided ?
- In a control system the output of the controller is given to__________?
- In a stable control system backlash can cause which of the following ?
- A controller, essentially, is a__________?
- Which of the following statements is correct for any closed loop system ?
- The transient response, with feedback system__________?
- Which of the following statements is correct for a system with gain margin close to unity or a phase margin close to zero ?
- The second derivative input signals modify which of the following ?
- increases the steady state accuracy?