A. at rest without any energy stored in it
B. working normally with reference input
C. working normally with zero reference input
D. at rest but stores energy
Correct Answer: at rest but stores energy ✔
Last Updated: December 23, 2018
Related MCQs
- A differentiator is usually not a part of a control system because it__________?
- In a control system integral error compensation __________ steady state error?
- An amplidyne can give which of the following characteristics ?
- __________directly converts temperature into voltage?
- Which of the following is exhibited by Root locus diagrams ?
- Which of the following is the output of a thermocouple ?
- __________From which of the following transfer function can be obtained ?
- __________By which of the following the system response can be tested better ?
- __________is the reference input minus the primary feedback?
- With feedback __________ increases?
- In a system zero initial condition means that__________?
- signal will become zero when the feedback signal and reference signs are equal?
- The transfer function is applicable to which of the following ?
- A signal other than the reference input that tends to affect the value of controlled variable is known as__________?
- The transient response of a system is mainly due to__________?
- The temperature, under thermal and electrical system analogy, is considered analogous to__________?
- In electrical-pneumatic system analogy the current is considered analogous to__________?
- In force-voltage analogy, velocity is analogous to__________?
- In liquid level and electrical system analogy, voltage is considered analogous to__________?
- In thermal-electrical analogy charge is considered analogous to__________?
- The viscous friction co-efficient, in force-voltage analogy, is analogous to__________?
- Mass, in force-voltage analogy, is analogous to__________?
- The capacitance, in force-current analogy, is analogous to__________?
- In an automatic control system which of the following elements is not used ?
- Due to which of the following reasons excessive bond width in control systems should be avoided ?
- In a control system the output of the controller is given to__________?
- In a stable control system backlash can cause which of the following ?
- A controller, essentially, is a__________?
- Which of the following statements is correct for any closed loop system ?
- The transient response, with feedback system__________?
- Which of the following statements is correct for a system with gain margin close to unity or a phase margin close to zero ?
- The second derivative input signals modify which of the following ?
- increases the steady state accuracy?
- Regenerative feedback implies feedback with__________?
- On which of the following factors does the sensitivity of a closed loop system to gain changes and load disturbances depend ?
- A control system with excessive noise, is likely to suffer from__________?
- A.C. servomotor resembles__________?
- The output of a feedback control system must be a function of__________?
- Transfer function of a system is used to calculate which of the following ?
- Zero initial condition for a system means__________?
- As a result of introduction of negative feedback which of the following will not decrease ?
- __________is an open loop control system?
- The band width, in a feedback amplifier__________?
- Which of the following devices are commonly used as error detectors in instruments ?
- By which of the following the control action is determined when a man walks along a path ?
- Which of the following should be done to make an unstable system stable ?
- __________is a closed loop system?
- A closed loop system is distinguished from open loop system by which of the following ?
- An automatic toaster is a __________ loop control system?
- For open control system which of the following statements is incorrect ?
- In closed loop control system, with positive value of feedback gain the overall gain of the system will__________?