A. increase
B. remain the same
C. decrease
D. cannot tell
Correct Answer: decrease ✔
Last Updated: July 30, 2021
Related MCQs
- The first goal to accomplish in analyzing a complex series-parallel circuit is to__________?
- The positive (+) and negative (-) ends of the battery are called __________?
- When a Wheatstone bridge is in a balanced condition, the center voltmeter in the bridge will read__________?
- In a series–parallel circuit, individual component power dissipation are calculated using__________?
- The current flowing through an unloaded voltage divider is called the__________?
- With 21 V applied, if R1 = 5 ohms, R2 = 35 ohms, and R3 = 14 ohms, what is the current of R2 if R1 is series connected with parallel circuit R2 and R3?
- If R1 is in series with parallel connected to R2 and R3, what happens to total current if R2 opens?
- A Wheatstone bridge can be used to determine an unknown__________?
- A device able to supply electrical energy is a __________?
- A 6 V battery output is divided down to obtain two output voltages. Three 2.2 kΩ resistors are used to provide the two taps. The two output voltages are__________?
- The internal resistance of a 20,000 ohm/volt voltmeter set on its 5 V range is__________?
- A certain voltage divider consists of three 1 kΩ resistors in series. Which of the following load resistors will have the least effect on the output voltage?
- Two 1.2 kΩ resistors are in series and this series combination is in parallel with a 3.3 kΩ resistor. The total resistance is__________?
- A certain voltage divider consists of two 12 kΩ resistors in series. Which of the following load resistors will have the most effect on the output voltage?
- The parallel combination of a 470 Ω resistor and a 680 Ω resistor is in series with the parallel combination of four 2 kΩ resistors. The total resistance is__________?
- The parallel combination of a 470 Ω resistor and a 1.5 kΩ resistor is in series with the parallel combination of five 1 kΩ resistors. The source voltage is 50 V. The percentage of the load current through any single 1 KΩ resistor is__________?
- On which of the following voltage range settings will a voltmeter present the minimum load on a circuit?
- The parallel combination of a 6.8 kΩ resistor and a 10 kΩ resistor is in series with the parallel combination of a 2.2 kΩ resistor and a 1 kΩ resistor. A 100 V source is connected across the circuit. The resistor(s) with the greatest voltage drop is (are)__________?
- The parallel combination of a 470 Ω resistor and a 1.2 kΩ resistor is in series with the parallel combination of three 3 kΩ resistors. A 200 V source is connected across the circuit. The resistor with the most current has a value of__________?
- A balanced Wheatstone bridge consists of an RV of 3,500 Ω, an R2 of 200 Ω, and an R3 of 680 Ω. The value of RUNK is__________?
- In a certain five-step R/2R ladder network, the smallest resistor value is 1 kΩ. The largest value is__________?
- Three 10 kΩ resistors are connected in series. A 20 kΩ resistor is connected in parallel across one of the 10 kΩ resistors. The voltage source is 24 V. The total current in the circuit is__________?
- A voltage divider consists of two 100 kΩ resistors and a 12 V source. What will the output voltage be if a load resistor of 1 MΩ is connected to the output?
- Two 3.3 kΩ resistors are in series and this series combination is in parallel with a 4.7 kΩ resistor. The voltage across one of the 3.3 kΩ resistors is 12 V. The voltage across the 4.7 kΩ resistor is_________?
- A certain circuit is composed of two parallel resistors. The total resistance is 1,403 Ω. One of the resistors is 2 kΩ. The other resistor value is__________?
- A certain Wheatstone bridge has the following resistor values: R1 = 10 kΩ, R2 = 720 Ω, and R4 = 2.4 kΩ. The unknown resistance is__________?
- A 12 kΩ resistor, a 15 kΩ resistor, and a 22 kΩ resistor are in series with two 10 kΩ resistors that are in parallel. The source voltage is 75 V. Current through the 15 kΩ resistor is approximately__________?
- A voltage divider consists of two 68 kΩ resistors and a 24 V source. The unknown output voltage is__________?