A. Instrumentation amplifiers
B. Voltage followers
C. Voltage regulators
D. Buffers
Correct Answer: Instrumentation amplifiers ✔
Last Updated: December 17, 2018
Related MCQs
- The two input terminals of an opamp are labeled as__________?
- For an op-amp having differential gain Av and common-mode gain Ac the CMRR is given by__________?
- Hysteresis is desirable in Schmitt-trigger, because__________?
- The output voltage Vo of the above circuit is__________?
- In the above circuit the current ix is__________?
- An opamp has a slew rate of 5V/ S. the largest sine wave o/p voltage possible at a frequency of 1MHz is__________?
- The approximate input impedance of the opamp circuit which has Ri=10k, Rf=100k, RL=10k?
- An amplifier using an opamp with slew rate SR=1v/sec has a gain of 40db.If this amplifier has to faithfully amplify sinusoidal signals from dc to 20KHz without introducing any slew-rate induced distortion, then the input signal level exceed__________?
- An ideal OP-AMP is an ideal__________?
- How many op-amps are required to implement this equation Vo = V1?
- How many op-amps are required to implement this equationop-amps?
- The ideal OP-AMP has the following characteristics
- If ground is applied to the (+) terminal of an inverting op-amp, the (–) terminal will__________?
- An ideal OP-AMP is an ideal__________?
- A non inverting closed loop op amp circuit generally has a gain factor__________?
- The closed-loop voltage gain of an inverting amplifier equal to__________?
- Calculate the cutoff frequency of a first-order low-pass filter for R1 = 2.5kΩ and C1 = 0.05μF__________?