A. Frequency response
B. Absolute stability
C. Relative stability
D. Time response
Correct Answer: Relative stability ✔
Last Updated: July 30, 2021
Related MCQs
- A.C. servomotor is basically a__________?
- Which of the following is the non-linearity caused by servomotor ?
- Which of the following is the best method for determining the stability and transient response ?
- The type 0 system has __________ at the origin?
- The position and velocity errors of a type-2 system are__________?
- __________technique is not applicable to nonlinear system ?
- __________is not a final control element?
- Pressure error can be measured by which of the following ?
- If the gain of the critical damped system is increased it will behave as__________?
- technique gives quick transient and stability response__________?
- With feed back __________ reduces?
- Which of the following can be measured by LVDT ?
- The first order control system, which is well designed, has a__________?
- The transfer function technique is considered as inadequate under which of the following conditions ?
- With feed back __________ reduces?
- Which of the following is an electromagnetically device ?
- __________can be extended to systems which are time-varying ?
- The effect of error damping is to__________?
- In pneumatic control systems the control valve used as final control element converts__________?
- The phase lag produced by transportation relays__________?
- Addition of zeros in transfer function causes which of the following ?
- If a step function is applied to the input of a system and the output remains below a certain level for all the time, the system is__________?
- Velocity error constant of a system is measured when the input to the system is unit __________ function?
- The type 2 system has __________ at the origin?
- Static error coefficients are used as a measure of the effectiveness of closed loop systems for specified __________ input signal?
- Spring constant in force-voltage analogy is analogous to__________?
- The frequency and time domain are related through which of the following ?
- The type 1 system has _________ at the origin?
- A conditionally stable system exhibits poor stability at__________?
- An increase in gain, in most systems, leads to__________?
- In a system low friction co-efficient facilitates__________?
- In order to increase the damping of a badly underdamped system which of following compensators may be used ?
- Which of the following can be measured by the use of a tachogenerator ?
- Which of the following is the definition of proportional band of a controller ?
- Which of the following devices is used for conversion of co-ordinates ?
- A phase lag lead network introduces in the output__________?
- When the initial conditions of a system are specified to be zero it implies that the system is__________?
- When the initial conditions of a system are specified to be zero it implies that the system is__________?
- A differentiator is usually not a part of a control system because it__________?
- In a control system integral error compensation __________ steady state error?
- An amplidyne can give which of the following characteristics ?
- __________directly converts temperature into voltage?
- Which of the following is exhibited by Root locus diagrams ?
- Which of the following is the output of a thermocouple ?
- __________From which of the following transfer function can be obtained ?
- __________By which of the following the system response can be tested better ?
- __________is the reference input minus the primary feedback?
- With feedback __________ increases?
- In a system zero initial condition means that__________?
- signal will become zero when the feedback signal and reference signs are equal?
- The transfer function is applicable to which of the following ?