A. through resistance
B. through reactances
C. through capacitors
D. solidly
Correct Answer: through resistance ✔
Last Updated: October 04, 2018
Related MCQs
- A repulsion motor is equipped with__________?
- Which of the following motors has two separate windings on the motor ?
- Which of the following statements regarding a reluctance motor is incorrect ?
- A shaded pole motor does not possess__________?
- To reverse the direction of rotation of acapacitor start motor while it is running we should__________?
- In case of a reluctance motor, when the load is increased so that it cannot maintain synchronous speed the motor will__________?
- Most of the fractional horsepower motors have either__________?
- In a universal motor, the most common cause of brush sparking is__________?
- Which of the following statements regarding reluctance-start motor is incorrect ?
- If starting winding of a single-phase induction motor is left in the circuit, it will__________?
- If the centrifugal switch of a two-value capacitor motor using two capacitors fails to open then__________?
- Which of the following statements regarding two value capacitor motor is incorrect ?
- If a single phase induction motor runs slower than normal, the most likely defect is__________?
- Two-value capacitor motor finds increased application as compressor motor in small home air-conditioners because__________?
- Which of the following motors is used in tape-recorders __________?
- Starting winding of a single phase motor of a refrigerator is disconnected from the circuit by means of a__________?
- Centrifugal switch disconnects the auxiliary winding of the motor at about ______ percent of synchronous speed?
- Which of the following motors is used in a situation where load increases with speed ?
- Which of the following motors is used for unity power factor ?
- In repulsion motor, zero torque is developed when__________?
- The motor used for the compressors is__________?
- The purpose of stator winding in the compensated repulsion motor is to__________?
- The rotor slots, in an induction motor, are usually not quite parallel to the shaft because it__________?
- In a ceilingfan employing capacitor run motor__________?
- The speed/load characteristics of a universal motor is same as that of__________?
- The shaded pole motor is used for__________?
- If the centrifugal switch does not open at 70 to 80 percent of synchronous speed of motor, it would result in_________?
- Speed torque characteristic of a repulsion induction motor is similar to that of a D.C__________?
- In split phase motor main winding is of __________?
- In repulsion motor, maximum torque is developed when__________?
- The rotor of a hysteresis motor is made of__________?
- Which of the following applications always have some load whenever switched on ?
- Torque developed by a single phase induction motor at starting is__________?
- The speed control of universal motor used for sewing machines is by__________?
- The electric motor used in portable drills is__________?
- In a hysteresis motor, the rotor must have__________?
- Locked rotor current of a shaded pole motor is__________?
- Which of the following statements regarding repulsion-start induction motor is incorrect ?
- After the starting winding of a single phase induction motor is disconnected from supply, it continues to run only on __________?
- A.C. series motor as compared to D.C. series motor has__________?
- Hysteresis motor is particularly useful for high-quality record players and tape-recorders because__________?
- Which of the following statements regarding single-phase induction motors correct?
- Speed control of a universal motor is achieved by__________?
- Which of the following statements regarding hysteresis motor is in incorrect?
- The starting winding of a single-phase motor is placed in_________?
- The speed of a universal motor is usually reduced by using__________?
- A reluctance motor__________?
- Which motor is normally free from mechanical and magnetic vibrations ?
- As hysteresis motors are free from mechanical and magnetic vibrations therefore these are considered as suitable for__________?
- The direction of rotation of universal motor can be reversed the by reversing the flow of current through__________?
- When a D.C. series motor is connected to A.C. supply, the power factor will be low because of__________?