If d is the diameter of bolt hole then for a flanged pipe joint to be leak proof, the circumferential pitch of the bolts should be__________?
The following type of nut is used with alien bolt__________?
Shear stress theory is applicable for__________?
For applications involving high stresses in one direction only the following type of thread would be best suited__________?
The function of a washer is to__________?
Ball bearing type screws are found in following application__________?
An alien bolt is__________?
Set screws are__________?
The deflection of a cantilever beam under load W is 8. If its width is halved, then the deflection under load W will be__________?
Cap screws are__________?
The included angle in unified of American National threads is__________?
A tap bolt__________?
A stud__________?
Maximum principal stress theory is applicable for__________?
The crest diameter of a screw thread is same as __________?
At low temperatures (say 75°C) the notched-bar impact value of steel__________?
For steel, the ultimate strength in shear as compared to ultimate strength in tension is __________?
Resistance to fatigue of a material is measured by__________?
The ratio of endurance limit in shear to the endurance limit in flexure is__________?
Residual stress in materials__________?
Cold working__________?
In nitrated parts, the origins of the fatigue cracks will occur at__________?
Which process will increase the fatigue duration of parts ?
The building up of worn and uridersized parts, subjected to repeated loads by electroplating is__________?
Yield point in fatigue loading as compared to static loading is__________?
The fatigue limit of a material__________?
The ultimate strength of steel in tension in comparison to shear is in the ratio of__________?
The permissible stress for carbon steel under static loading is generally taken as__________?
A hot short metal is__________?
Rankine’s theory of failure is applicable for following type of materials__________?
Tensile strength of a mild steel specimen can be roughly predicted from following hardness test__________?
In the case of an elastic bar fixed at upper end and loaded by a falling weight at lower end, the shock load produced can be decreased by__________?
If a load W is applied instantaneously on a bar; then the stress induced in bar will__________?
Stress concentration is caused due to__________?
Plastic flow in ductile materials__________?
The fatigue life of a part can be improved by__________?
Stress concentration in cyclic loading is more serious in__________?
Fatigue strength can be increased by__________?
Coaxing is the procedure of increasing__________?
The notch angle of the Izod impact test specimen is__________?
In testing a material for endurance strength, it is subjected to__________?
In Vicker’s hardness testing, the pyramid indentor apex is__________?
If a material fails below its yield point, failure would be due to__________?
Stress concentration in cyclic loading is__________?
Stress concentration in static loading is__________?
Which of the following is not correct procedure to increase the fatigue limit__________?
Endurance limit or fatigue limit is the maximum stress that a member can withstand for an infinite number of load applications without failure when subjected to__________?
Stress concentration in static loading is more serious in__________?
The maximum stress due to stress concentration in a bar having circular transverse hole, as compared to its static stress without hole will be__________?
The endurance limit of a material with finished surface in comparison to rough surface is__________?
Brittle coating technique is used for__________?

A bolt___________________?

A. has a head on one end and a nut fitted to the other
B. has head at one end and other end fits into a tapped hole in the other part to be joined
C. has both the ends threaded
D. is provided with pointed threads
E. requires no nut

Correct Answer: has a head on one end and a nut fitted to the other ✔

Last Updated: January 26, 2019