A. 0.2
B. 0.25
C. 0.50
D. 0.6
E. 0.75
Correct Answer: 0.2 ✔
Last Updated: January 27, 2019
Related MCQs
- Jam nut is a locking device in which __________?
- Buttress threads are usually found on__________?
- A key capable of tilting in a recess milled out in a shaft is known as__________?
- A tapered key which fits in a keyway in the hub and is flat on the shaft, is known as__________?
- Turn buckle has__________?
- Elastic nut is a locking device in which__________?
- If threads on a bolt are left hand, threads on nut will be__________?
- Applications in which stresses are encountered in one direction only uses following type of threads__________?
- A bench vice has following type of threads__________?
- Split nut is a locking device in which__________?
- The function of cutting oil when threading a pipe is to__________?
- For tight leakage joints, following type of thread is best suited __________?
- A tube has the following advantage over pipe__________?
- A backing ring is used inside the pipe joint when making a__________?
- Castle nut is a locking device in which__________?
- Gear box is used__________?
- The piston rod of a steam engine is usually connected to the cross head by means of__________?
- Spring index is__________?
- Form coefficient of spring is __________?
- When two springs are in series (having stiffness K), the equivalent stiffness will be__________?
- If a spring is cut down into two springs, the stiffness of cut springs will be __________?
- Aircraft body is usually fabricated by__________?
- In hydrodynamic bearings__________?
- If p = bearing pressure on projected bearing area, z = absolute viscosity of lubricant, and N = speed of journal, then the bearing characteristic number is given by__________?
- In hydrostatic bearings __________?
- The rated life of a bearing varies__________?
- In V-belt drive, belt touches__________?
- In cross or regular lay ropes__________?
- If shearing stress in nut is half the tensile stress in a bolt, then nut length should be equal to__________?
- Basic hole is one__________?
- For standard coarse threads of nut, the threads will be as strong in failure by shear as the bolt in tension, if the height of nut (h) is approximately__________?
- The resultant axial load on a bolt depends on__________?
- When a bolt is subjected to shock loading, the resilience of the bolt should be considered in order to prevent breakage at__________?
- The connecting rod bolts are tightened up with initial tension greater than the external load so that__________?
- The shock absorbing capacity of a bolt can be increased by__________?
- If an application calls for stresses on screw threads in one direction only, then the following type of thread would be best suited __________?
- The connecting rod bolts are tightened up so that tightening stress __________?
- Allen bolts are__________?
- I.S. specifies following total number of grades of tolerances__________?
- In composite or reverse laid ropes__________?
- Basic shaft is one__________?
- Whether any core is required in wire ropes__________?
- In standard taper roller bearings, the angle of taper of outer raceway is__________?
- Three different weights fall from a certain height under vacuum. They will take__________?
- In oilness bearings__________?
- Oil in journal bearing should be applied at the point where load is__________?
- The usual clearance provided in hydrodynamic bearing per mm of diameter of shaft is__________?
- Antifriction bearings are__________?
- If two springs are in parallel then their overall stiffness will be__________?
- Belt slip may occur due to__________?
- When a close coiled helical spring is compressed, its wire is subjected to__________?