A. Young’s modulus
B. coefficient of elasticity
C. elastic limit
D. ultimate tensile strength
E. endurance limit
Correct Answer: endurance limit ✔
Last Updated: January 26, 2019
Related MCQs
- The ratio of endurance limit in shear to the endurance limit in flexure is__________?
- Residual stress in materials__________?
- Cold working__________?
- In nitrated parts, the origins of the fatigue cracks will occur at__________?
- Which process will increase the fatigue duration of parts ?
- The building up of worn and uridersized parts, subjected to repeated loads by electroplating is__________?
- Yield point in fatigue loading as compared to static loading is__________?
- The fatigue limit of a material__________?
- The ultimate strength of steel in tension in comparison to shear is in the ratio of__________?
- The permissible stress for carbon steel under static loading is generally taken as__________?
- A hot short metal is__________?
- Rankine’s theory of failure is applicable for following type of materials__________?
- Tensile strength of a mild steel specimen can be roughly predicted from following hardness test__________?
- In the case of an elastic bar fixed at upper end and loaded by a falling weight at lower end, the shock load produced can be decreased by__________?
- If a load W is applied instantaneously on a bar; then the stress induced in bar will__________?
- Stress concentration is caused due to__________?
- Plastic flow in ductile materials__________?
- The fatigue life of a part can be improved by__________?
- Stress concentration in cyclic loading is more serious in__________?
- Fatigue strength can be increased by__________?
- Coaxing is the procedure of increasing__________?
- The notch angle of the Izod impact test specimen is__________?
- In testing a material for endurance strength, it is subjected to__________?
- In Vicker’s hardness testing, the pyramid indentor apex is__________?
- If a material fails below its yield point, failure would be due to__________?
- Stress concentration in cyclic loading is__________?
- Stress concentration in static loading is__________?
- Which of the following is not correct procedure to increase the fatigue limit__________?
- Endurance limit or fatigue limit is the maximum stress that a member can withstand for an infinite number of load applications without failure when subjected to__________?
- Stress concentration in static loading is more serious in__________?
- The maximum stress due to stress concentration in a bar having circular transverse hole, as compared to its static stress without hole will be__________?
- The endurance limit of a material with finished surface in comparison to rough surface is__________?
- Brittle coating technique is used for__________?
- Other method of reducing shock load in the above case can be__________?
- Resilience of a material is important, when it is subjected to__________?
- If an unsupported uniform cross sectional elastic bar is subjected to a longitudinal impact from a rigid bob moving with velocity v, then a compressive wave of intensity sc is propagated through the bar as follows__________?
- Guest’s theory of failure is applicable for following type of materials__________?
- The property of a material which enables it to resist fracture due to high impact loads is known as__________?