A. flaring
B. brazing
C. soft soldering
D. fusion welding
E. none of the above
Correct Answer: brazing ✔
Last Updated: January 27, 2019
Related MCQs
- Taper on the cotter and slot is provided__________?
- The valve rod in a steam engine is connected to an eccentric rod by__________?
- The draw of cotter need not exceed__________?
- Taper usually provided on cotter is__________?
- If d is the normal diameter of a bolt in mm, then the initial tension in kg in a bolt used for making a fluid tight joint as for steam engine cover joint is calculated by the relation__________?
- Eye bolts are used for__________?
- Fibrous fracture occurs in__________?
- A key made from a cylindrical disc having segmental cross-section, is known as__________?
- In order to obtain bolt of uniform strength__________?
- The pitch of threads on a Jock nut in comparison to pitch of nut is__________?
- Transverse fillet welded joints are designed for__________?
- In order to avoid tearing of the plate at edge, the distance from the center line of the rivet hole to the nearest edge of the plate in terms of dia of rivet d should be equal to__________?
- The edges of a boiler plate are bevelled to an angle of__________?
- Machine screws are__________?
- A self locking screw has__________>
- Which is correct statement ?
- The endurance limit in shear of carbon steel can be obtained by multiplying the endurance limit in flexure by a factor of__________?
- A bolt__________?
- If d is the diameter of bolt hole then for a flanged pipe joint to be leak proof, the circumferential pitch of the bolts should be__________?
- The following type of nut is used with alien bolt__________?
- Shear stress theory is applicable for__________?
- For applications involving high stresses in one direction only the following type of thread would be best suited__________?
- The function of a washer is to__________?
- Ball bearing type screws are found in following application__________?
- An alien bolt is__________?
- Set screws are__________?
- The deflection of a cantilever beam under load W is 8. If its width is halved, then the deflection under load W will be__________?
- Cap screws are__________?
- The included angle in unified of American National threads is__________?
- A tap bolt__________?
- A stud__________?
- Maximum principal stress theory is applicable for__________?
- The crest diameter of a screw thread is same as __________?
- At low temperatures (say 75°C) the notched-bar impact value of steel__________?
- For steel, the ultimate strength in shear as compared to ultimate strength in tension is __________?
- Resistance to fatigue of a material is measured by__________?
- The ratio of endurance limit in shear to the endurance limit in flexure is__________?
- Residual stress in materials__________?
- Cold working__________?
- In nitrated parts, the origins of the fatigue cracks will occur at__________?
- Which process will increase the fatigue duration of parts ?
- The building up of worn and uridersized parts, subjected to repeated loads by electroplating is__________?
- Yield point in fatigue loading as compared to static loading is__________?
- The fatigue limit of a material__________?
- The ultimate strength of steel in tension in comparison to shear is in the ratio of__________?
- The permissible stress for carbon steel under static loading is generally taken as__________?
- A hot short metal is__________?
- Rankine’s theory of failure is applicable for following type of materials__________?
- Tensile strength of a mild steel specimen can be roughly predicted from following hardness test__________?
- In the case of an elastic bar fixed at upper end and loaded by a falling weight at lower end, the shock load produced can be decreased by__________?
- If a load W is applied instantaneously on a bar; then the stress induced in bar will__________?